1963-1979 Corvette C2 & C3 Rear Axle Half Shaft 3.5 inch 6061-T6 Aluminum
|
Part Number: AL3.5-6379HS
|
Your Cost
$390.95
Sorry, sold out
STATUS:
Not available at this time
|
|
1963-1979 Corvette C2 & C3
3.5 inch 1350 series ALUMINUM Half Shaft
For Stock Corvettes
Be sure to check clearance for larger tube diameter
PRICE SHOWN is for (1) Half Shaft
UPC:
Part Number: AL3.5-6379HS
|
Denny's Rear Axle Half Shaft 1963-1979 Corvette C2 & C3 3.5 inch 6061-T6 Aluminum
|
STATUS: Not available at this time
YOUR COST:
$390.95
OVERSIZE PACKAGE: Sorry ... this item DOES NOT qualify for Free Shipping!
|
1963-1979 Corvette C2 & C3 Rear Axle
3.5 inch 1350 series ALUMINUM Half Shaft complete with Spicer 1350 series maintenance free u-joints and flange yoke.
All Denny’s Corvette Axle Half Shafts are high speed balanced and come fully assembled for easy installation.
No greasy mess splattered all over that nice Corvette from these super strong and reliable u-joints and you can expect very high mileage with no maintenance. Don’t get these confused with those inexpensive unbalanced no name shafts that seem to be all over the internet for a whole lot less. Buy with confidence knowing that they are built with our Nitrous Ready tubing for the ultimate in strength and reliability.
- 1350 Series
- 3.5 inch ALUMINUM Tubing...Be sure to check clearance for larger diameter tube
- Spicer solid body maintenenace free 1350 series u-joints
- Flange yoke
- High Speed Balanced and Tested
- Fully assembled and ready to install
- Dimensions not necessary unless custom length is required
PRICE SHOWN is for (1) Half Shaft
|
Measure from CENTER of pressed in cap to CENTER of pressed in cap
Please measure from the exact center of the u-joint cap diameters at each end of the shaft for an accurate center to center overall length dimension to order any half shaft. Please measure the universal joint cap diameter carefully. The 1330 series (usually found on early eighty’s half shafts) will have a 1 1/16th inch (1.062) u-joint cap diameter and the 1350 series (usually found on all years steel or aluminum) will have a 1 3/16th inch (1.187) u-joint cap diameter.
|
Denny's Rear Axle Half Shaft 1963-1979 Corvette C2 & C3 3.5 inch 6061-T6 Aluminum
|
|