I just wanted to send a compliment. In 1992, I had an
old motorhome that I'd done an engine and tranny swap on and
needed a C-6 yoke for a 1350 u-joint. I found you in a
Street rod magazine. I've never once had an issue with your
yoke. I've taken... ...read more
Denny's Driveshafts offer a variety of Chevrolet Corvette Driveshafts for the C1, C2, C3 and C4. All Denny's Driveshafts include the appropriate transmission slip yoke and universal joints. Our Corvette Driveshafts can be built as a stock replacement or custom made to accommodate the needs and requirements of your exact vehicle application. All Denny’s Driveshafts and axle half shafts are High Speed Balanced and tested to be sure they will run smooth throughout your full rpm and driving range. Our Corvette Rear Half Shafts are designed and custom built in 3 different versions to suit the needs of just about any application. If you are looking for the ultimate strength we have the 1350 series Nitrous Ready in 3 inch and 3.5 inch for the most demanding Corvette. If you want an aluminum half shaft we have the 3.5 inch 1350 series 6061-T6 Aluminum to choose from. Both are excellent choices. The 1963-1979 Corvette requires a Flange Yoke to mount it at the wheel side and we also have them available as shown below.
Measure from CENTER of pressed in cap to CENTER of pressed in cap
Please measure from the exact center of the u-joint cap diameters at each end of the shaft for an accurate center to center overall length dimension to order any half shaft. Please measure the universal joint cap diameter carefully. The 1330 series (usually found on early eighty’s aluminum half shafts) will have a 1 1/16th inch (1.062) u-joint cap diameter and the 1350 series (usually found on all years steel or aluminum) will have a 1 3/16th inch (1.187) u-joint cap diameter.
