|
Dana Spicer 3-2-809 Flange Yoke fits CORVETTE Rear Axle 1963-1979 1350 Series
|
||||||
|
||||||
|
Dana Spicer 3-2-809 Flange Yoke fits CORVETTE Rear Axle 1963-1979
 |
||||||
Dana Spicer 3-2-809 Flange Yoke fits CORVETTE Rear Axle 1963-1979 1350 Series
|
FOR FASTER SERVICE, PLEASE ORDER ALL PARTS ONLINE
STATUS: IN STOCK
YOUR COST:
You Save $6.13
|
|||||
|
Dana Spicer 3-2-809 Flange Yoke fits CORVETTE Rear Axle 1963-1979
Installation Tip: When changing a flange yoke on any 1963-1979 Corvette half shaft you should be carefull to never strike the flange yoke or driveshaft with a hammer. The u-joint must be pressed into place and care must be given not to ever squeeze the driveshaft tubing in a vise. This will cause permanent damage! Also a Corvette flange yoke can be bent if not supported properly while pressing the u-joint into place. The best way to achieve this is to bolt the flat flange surface to a heavy piece of steel plate so it cannot bend while you are working on it. |
||||||
|
|
||||||
|
||||||
You May Also Need These Parts to Complete the Job |
||||||
