Denny's 2 Piece Driveshafts for your Street Rod or High Performance Truck

• Can be built in 1310, 1330 and 1350 Series
• Complete 2 Piece Driveshaft ready to bolt in
• High Speed Balanced for smooth trouble free performance
• 1310 & 1330 Series ... Priced from $595.95
• 1350 Series ... Priced from $695.95
• Rubber or Urethane Mounted Center Bearing available 

Replace that worn out vibrating 2 piece driveshaft in your car, van or pick-up with a super smooth DENNY'S 2 piece driveshaft and enjoy a vibration free ride once again.

Our 2 piece driveshafts will run smooth and vibration free and the u-joints will last longer too.

DENNY'S 2 piece driveshafts are HIGH SPEED BALANCED as a complete assembly. This is the ONLY way to do it right.

We also TEST each shaft to be sure it will run as smooth for you as it did for us. No guess work here!

With our process of building, balancing and testing we can offer you a 2 piece shaft that will deliver extremely high rpm use without the annoying vibration associated with this type of shaft.

Whether your vehicle is for family use, a work truck, maybe its your car hauler or even if you race it we have a 2 piece driveshaft for you.

Let  DENNY'S design your next 2 piece driveshaft.

Click Here for Diagram "M"...Use for typical 2 piece with slip yoke at rear of transmission
Click Here for Diagram "N"...Use for typical 2 piece with no slip yoke at rear of transmission
Click Here for Diagram "O"...Use for typical 2 piece found in 1958-1964 Chevrolet cars and

                                                      half ton Chevy pickups up to 1972

           Check out the two piece driveshafts built specifically for the early Chevrolet 1958-1964 cars and 1955-1972 Chevy Light Trucks.  Our 3 inch Heavy Duty design with aluminum urethane mounted center support hanger bearing is great to eliminate the typical driveline failures associated with the original equipment design of the early 2 piece driveshafts.  This shaft is perfect for air ride suspensions and will handle the horsepower and rpm of todays high performance street and race vehicles. 

           CLICK HERE to read more!

As seen on TRUCKS TV the Haulin S-10 uses a Denny's 2 Piece Driveshaft.  Our 1350 series Nitrous Ready 2 Piece can handle the abuse of high horsepower and high rpm in long wheelbase vehicles.