DennysDriveshaft.com
Free Shipping on Orders Over $99.00

Product Search
Denny's Driveshaft builds custom steel and aluminum driveshafts for your high performance car, street rod, race car, van, pick up or 4x4 truck
 
Dodge 3R Series Double Cardan CV Flange Yoke
Part #:
N3R-83-482
Your Cost $66.35

Double Cardan 3R Series CV Flange Yoke to replace original equipment Dodge 4x4 CV Flange Yoke.  Use this to replace your worn out CV flange yoke. 

Comes with ball socket centering parts already installed for easy installation.

Neapco
Dodge 3R Series Double Cardan CV Flange Yoke
Dodge 3R Series Double Cardan CV Flange Yoke
FOR FASTER SERVICE, PLEASE ORDER ALL PARTS ONLINE
STATUS:  IN STOCK
YOUR COST:  $66.35

Double Cardan 3R Series CV Flange Yoke to replace original equipment Dodge 4x4  CV Flange yoke.  This yoke is used to replace the 4x4 double cardan CV Flange yoke located on the Front Driveshaft of a 4x4 Dodge original equiment driveshaft.  CV Flange yoke comes complete with ball socket centering parts already loaded.  Bolt pattern for mounting to rear differential flange is 4 1/4 inches (4.250 inches) measured diagonally and the pilot hole in the center of the flat flange is 3 1/8 inches (3.125 inches).   It has 4 equally spaced holes that measure 3 inches from center of hole to center of hole.

  • Dodge 3R Series Double Cardan CV Flange Yoke
     
  • Bolt Pattern.... 4.25 inches (4 1/4 inches) measured diagonally
  • Pilot Diameter... 3.125 inches (3 1/8 inches)
  • Typically found on Dodge 4x4 Front Driveshafts 1973 and newer with inside "C" Clip style u-joints. 
  • Requires Inside "C" Clip style 3R Series u-joints listed below 
  • Centering ball socket comes fully assembled and ready to install 

 

Dodge 3R Series Double Cardan CV Flange Yoke

Dodge 3R Series Double Cardan CV Flange Yoke

You May Also Need These Parts to Complete the Job


DennysDriveshaft.com - © Copyright 2017-Present

Website and Web Hosting by Online Media
Online Media - Buffalo's Web Hosting Company