| 1963-1979 Corvette 1350 Series Flange Yoke | ||||||
|
||||||
|
1350 series flange yoke to replace your bent, rusted or damaged original equipment rear axle half shaft flange yoke. Genuine DANA SPICER Part |
||||||
|
FOR FASTER SERVICE, PLEASE ORDER ALL PARTS ONLINE
$57.95 each
STATUS: IN STOCK
|
|||||
|
1350 series flange yoke to replace your bent, rusted or damaged original equipment rear axle half shaft flange yoke. Genuine DANA SPICER Part Installation Tip: When changing a flange yoke on any 1963-1979 Corvette half shaft you should be carefull to never strike the flange yoke or driveshaft with a hammer. The u-joint must be pressed into place and care must be given not to ever squeeze the driveshaft tubing in a vise. This will cause permanent damage! Also a Corvette flange yoke can be bent if not supported properly while pressing the u-joint into place. The best way to achieve this is to bolt the flat flange surface to a heavy piece of steel plate so it cannot bend while you are working on it. |
||||||
|
|
||||||
|
||||||
Additional Items to Complete the Job
|
||||||
|
||
