Rebuild kit for Corvette Aluminum DRIVESHAFT and rear axle HALF SHAFTS.

Includes (4) 1350 Series Spicer MAINTENANCE FREE U-Joints and (4) Spicer Strap & METRIC Bolt Sets for the rear axle Half Shafts.   PLUS (2) 1310 Series Spicer MAINTENANCE FREE U-Joints and (1) 1310 Series Strap & Bolt Set for the Main Driveshaft. 

Everything you need to rebuild your existing 1984-1996 Corvette 1310 series Aluminum Main Driveshaft and 1350 series Aluminum Half Shafts.  Will fit original equipment and aftermarket aluminum 1310 series Main Driveshaft and 1350 series aluminum Half Shafts.

Spicer maintenance free solid body u-joints are a super strong high mileage universal joint ready to install.   No greasy mess from these to splatter all over your meticulously maintained or restored car. 

• Spicer 1350 Series MAINTENANCE FREE U-Joint  for Half Shafts
• 1350 series measures
  • 3.625 inches wide in both directions
  • All 4 bearing caps are 1.187 inch diameter
  • Outside snap rings

• Spicer 1310 Series MAINTENANCE FREE U-Joint for Main Driveshaft

• 1310 series measures

  • 3.219 inches wide in both directions
  • All 4 bearing caps are 1.0625 inch diameter
  • Outside snap rings
• Spicer 1350 series Strap and Bolt set for Half Shafts
  • Each set comes with (2) Straps and (4) METRIC Bolts to replace that old stretched out original set with a new one.
• Spicer 1310 series Strap and bolt set for Main Driveshaft
  • Set comes with (2) Straps and (4) Bolts to replace that old stretched out original set with a new one.

Please note:  We do not sell universal joints based on year, make and model. Too many mistakes are made this way because too many vehicles are modified.  Instead we sell them based on actual dimensions so that you get the right u-joint when you receive it.  To order you must measure how wide your u-joint is in both directions and the bearing cap diameters of all 4 caps.  This must be done at each end of your driveshaft.