Corvette U-Bolt Sets and Strap & Bolt Sets
Denny's Driveshafts offer a variety of Chevrolet Corvette attaching hardware for the C1, C2, C3 and C4. The typical Corvette rear end pinion yoke utilizes a strap and bolt design to hold the rear universal joint into the yoke. Disconnecting the 4 bolts and 2 straps is necessary to remove the driveshaft to from the car. Denny's offers both the original equipment strap and bolt set and also the u-bolt set as replacements to match your existing pinion yoke hardware. Please measure your u-joint width before ordering. The 1310 u-joint will measure 3.219 wide and the 1330 will measure 3.625 wide. Both will have a 1.062 bearing cap diameter.
| 1 Matching Results Found |
| Results per Page: |
