NEAPCO N3-83-3281X Double Cardan 1350 CV Flange Yoke fits DODGE RAM 2500 RAM 3500 4x4 2006 to 2010 AAM Front Driveshaft

NEAPCO N3-83-3281X

• DODGE RAM 2500 RAM 3500 4x4
• 1350 Series Double Cardan CV Flange Yoke
• Fits 2006 to 2010 AAM Front Driveshaft

DODGE Double Cardan CV Flange Yoke 1350 Series.  Non Greaseable Maintenance Free design. Mounts to any Dodge Double Cardan CV style transfer case flange with 3.125 pilot.  Use this CV flange yoke to attach a 1350 Series Double Cardan CV driveshaft to a Dodge 4x4 Transfer Case.  

Typically found on Dodge 4x4 front driveshafts with outside snap ring style 1350 series universal joints.

• 1350 Series Double Cardan CV Flange Yoke
• Use with 1350 Series greaseable u-joints listed below.
  
  • Does not work with non greaseable Dana Spicer 5-1350X or 5-1350-1X greaseable universal joints because the body of the u-joint it too large to flex freely in this yoke
• Needle Bearing Ball Socket fits 1/2 inch stud yoke
• Maintenance Free
• Comes with New Spring included
• Bolt Pattern.... 4.25 inches measured diagonally
• Pilot Diameter... 3.125 inches (3 1/8 inches)
• Bearing cap diameter is 1.187 (1 3/16th) for all 1350 series CV Flange yokes 
• Centering Yoke Fits 1350 Series Universal Joint
  • Dimension between snap rings on centering yoke is (3.625 inches) 3 5/8 inches
  • Designed to fit (1.187 inches) 1 3/16 inch U-Joint Bearing cap

It is recommended that you install a new rubber boot every time you service the Double Cardan CV joint. 

Please see the bottom of this page for new rubber boot.