Mustang 3 inch Driveshaft 1330 Series to fit all 7.5 inch and 8.8 inch with SMALL bolt pattern flat flange

Mustang Driveshaft 3 inch Steel DOM Tubing

COMPLETE Fully Assembled High Speed High RPM Balanced Driveshaft including 28 or 31 spline transmission slip yoke and Spicer u-joints custom built to fit your Mustang

• 3 Inch DOM Steel Tubing
• High Speed High RPM Balanced and Tested to be sure it will perform smoothly at all road speeds
• Maintenance Free Spicer U-joints...High Mileage and No Messy Grease Splatter
• For use in Mustangs with less than 700 horsepower.
• Maximum center to center is 52 inches  
• Fits Ford 7.5 inch and Ford 8.8 inch rear end with SMALL bolt pattern...2.5 inch by 2.5 inch bolt pattern

DENNY'S 3 inch Ford Mustang DRIVESHAFTS can be built to connect the transmissions listed below to any 1330 series Ford 7.5 inch or Ford 8.8 inch rear end. 

• All FORD 28 spline Manual or Automatic transmissions
• All FORD 31 spline Manual or Automatic transmissions

   
   

PLEASE SPECIFY: Model name or number of your transmission and also the spline count of the output shaft when ordering.

MEASUREMENTS REQUIRED TO ORDER THIS SHAFT

• CLICK HERE to View and Print DIAGRAM "K" 
  • On Diagram "K" your overall length dimension "Number 55" should be approximately 57 inches or less 

OVERSIZE PACKAGE: Sorry ... this item DOES NOT qualify for Free Shipping!