Mustang 3.5 inch ALUMINUM Driveshaft 1330 Series to fit all 7.5 inch and 8.8 inch with LARGE bolt pattern flat flange

Mustang Driveshaft 3.5 inch ALUMINUM

COMPLETE Fully Assembled High Speed High RPM Balanced Driveshaft including 28 or 31 spline transmission slip yoke and Spicer u-joints custom built to fit your Mustang

• 3.5 Inch ALUMINUM
• High Speed High RPM Balanced and Tested to be sure it will perform smoothly at all road speeds
• Maintenance Free Spicer U-joints...High Mileage and No Messy Grease Splatter
• For use in Mustangs with less than 700 horsepower.
• Maximum center to center is 57 inches  
• Fits Ford 7.5 inch and Ford 8.8 inch rear end with LARGE bolt pattern...3 inch by 3 inch bolt pattern

DENNY'S 3.5 inch Ford Mustang DRIVESHAFTS can be built to connect the transmissions listed below to any 1330 series Ford 7.5 inch or Ford 8.8 inch rear end. 

• All FORD 28 spline Manual or Automatic transmissions
• All FORD 31 spline Manual or Automatic transmissions

   
   

PLEASE SPECIFY: Model name or number of your transmission and also the spline count of the output shaft when ordering.

MEASUREMENTS REQUIRED TO ORDER THIS SHAFT

• CLICK HERE to View and Print DIAGRAM "K" 
  • On Diagram "K" your overall length dimension "Number 55" should be approximately 57 inches or less 

OVERSIZE PACKAGE: Sorry ... this item DOES NOT qualify for Free Shipping!