DANA SPICER 5-1350X UNIVERSAL JOINT 1350 Series Non-Greasable UNCOATED U-Joint for 1963 to 1996 Corvette rear axle half shafts

DANA SPICER 5-1350X

1350 Series MAINTENANCE FREE U-Joint.  Spicer maintenance free solid body u-joints are super strong high mileage universal joint ready to install.   No greasy mess from these to splatter all over your meticulously restored car. 

• UNCOATED Spicer 5-1350X MAINTENANCE FREE Solid Body U-Joint...Very strong , high mileage with no greasy mess splattered all over your beautifully restored chassis
• NON GREASEABLE
• Fits 1350 series Corvette Rear Axle Half Shafts in the following years
  • 1963, 1964, 1965, 1966, 1967, 1968, 1969
  • 1970, 1971, 1972, 1973, 1974, 1975, 1976, 1977, 1978, 1979
  • 1980, 1981, 1982, 1983, 1984, 1985, 1986, 1987, 1988, 1989
  • 1990, 1991, 1992, 1993, 1994, 1995, 1996
• 1350 series dimensions
  • 3.625 inches wide in both directions
  • All 4 bearing caps are 1.187 inch diameter
  • outside snap rings

IMPORTANT NOTE DISCLAIMER:

Technically the Aluminum Half Shafts should use the COATED Universal Joints (see Spicer 5-3615X) but it seems that many 1984 to 1996 Corvette owners have used the Spicer 5-1350X UNCOATED universal joints with great success.  They DID NOT experience any corrosion or problems in using the uncoated u-joints in their aluminum shafts.  While it is not recommended to use uncoated u-joints it seems that it is commonly done without any detrimental effects.  Please make your choice carefully.

If you need 4 Universal Joints then scroll down to select the Rebuild Kit at the bottom of your page.