Denny's SRHD35-S1 Street Rod HD Driveshaft 3.5 inch Stage 1 complete with Dana Spicer U-Joints and Sonnax 1310 Forged Slip Yoke

Denny's SRHD35-S1

Street Rod HD Driveshaft 3.5 inch Stage 1 with Sonnax 1310 Slip Yoke

• STAGE 1 is recommended for use with less than 500 horsepower.
  • For higher horsepower please see our 3.5 inch Stage 2 Street Rod HD Driveshaft
    

STAGE 1 Includes:

• Large 3.5 inch Diameter Tube - DOM Steel
  • Bigger is better for long length drivelines and also to achieve a higher safe critical speed if needed.
  • "IF YOU CAN POSSIBLY TWIST OUR STREET ROD STEEL DRIVESHAFT TUBING OR BREAK OUR WELDS...WE'LL REPLACE IT FREE"
  • All Denny's Driveshafts are assembled using the latest computer controlled welding equipment for the strongest welds possible.
• SONNAX 1310 series FORGED SLIP YOKE
  • Available to fit all 27 and 32 spline GM automatic transmissions
  • Available to fit all 27 and 32 spline Muncie, Borg Warner, AutoGear, Saginaw, Richmond
  • Available to fit 28 spline Ford C4 and AOD automatics (NOT available in 1310 for 4R70W see Stage 2 shafts)
  • Available to fit 28 spline T5, T10, Top Loader, Tremec TKO 600, T56 Magnum
• Dana Spicer NON Greaseable Universal Joints
  • FRONT universal joint 1310 series to match slip yoke
    
  • REAR universal joint can be 1310, 1330, 1350, 7260, 7290, 3R to match your rear end pinion yoke.
• All Denny's Driveshafts are High Speed - High RPM Balanced and Tested for smooth operation.  This is priceless when it comes to customer satisfaction!
• All Denny's Driveshafts come Fully Assembled and ready to bolt in!
• 
  • Denny's Free Lifetime Labor means for example if you ever need it shortened, re-balanced, change u-joints....the Labor is FREE    
    • Please see our Free Lifetime Labor page for details. CLICK HERE
      

HOW TO MEASURE

You have 2 choices ...see both choices below

CHOICE >>>>>> If your rear end has a u-bolt or strap and bolt style PINION YOKE then use Diagram "B": 

• MAXIMUM LENGTH restrictions for SRHD35-S1:
  
  • DIAGRAM "B" ...Number "B6" should be approximately 63 inches or less. 
• CLICK HERE to see Diagram "B" now

CHOICE >>>>>> Use Diagram "K" ONLY if you have a Ford 8.8 or JAG rear with a FLAT FLANGE.

• PLEASE NOTE:  There will be an Additional cost for the correct flange yoke.
• MAXIMUM LENGTH restrictions for SRHD35-S1:
  
  • DIAGRAM "K" ...Number "55" should be approximately 65 inches or less. 
    • CLICK HERE to see Diagram "K" now
  • DIAGRAM "L" ...we will also need NUMBERS 58, 59 and 60 on this page to build your order
    
    • CLICK HERE to see Diagram "L" now
• 
  

OVERSIZE PACKAGE: Sorry ... this item DOES NOT qualify for Free Shipping!