Mustang 1964-1966 REAR Universal Joint with Inside Snap Rings

Greaseable Universal Joint for REAR of 1964-1966 Mustang. 

Connects driveshaft to rear end pinion yoke.   Used on the early Mustangs and can be easily identified by the small 1 inch diameter bearing caps and that there are no visible outside snap rings as usually found on most Ford Mustang driveshafts.

• GREASEABLE U-Joint
• Dimensions: 
  • Dimension "A" = The span between the yoke inner surfaces where the "C" Clips lock in at the driveshaft is 2.344 inches
  • Dimension "C" = 2 bearing caps are 1 inch diameter with inside "C" Clips to lock the cap in place. 
  • Dimension "D" = 2 bearing caps are 1.125 inch diameter where it connects to pinion yoke
  • Dimension "B" = 1310 SERIES is 3.219 inches wide where it connects to pinion yoke
  • This universal joint is commonly used to connect the driveshaft to the rear end pinion yoke 

Please note:  We do not sell universal joints based on year, make and model. Too many mistakes are made this way because too many vehicles are modified.  Instead we sell them based on actual dimensions so that you get the right u-joint when you receive it.  To order you must measure how wide your u-joint is in both directions and the bearing cap diameters of all 4 caps.  This must be done at each end of your driveshaft.   

Looking for a new driveshaft for your Mustang?

How about a stronger and smoother running steel or aluminum driveshaft to fit your Mustang?

• STEEL DRIVESHAFT....CLICK HERE for DETAILS
• ALUMINUM DRIVESHAFT....CLICK HERE for DETAILS