DennysDriveshaft.com
Free Shipping on Orders Over $99.00

Product Search
Denny's Driveshaft builds custom steel and aluminum driveshafts for your high performance car, street rod, race car, van, pick up or 4x4 truck
 
350083-51 Spline and Slip yoke set 1310 series fits 3.5 inch 0.083 wall steel tube allows maximum 3 inches of slip travel
Part Number:
350083-51


UPC:
Your Cost $198.95
STATUS:  IN STOCK - FREE SHIPPING

350083-51

Spicer Spline and Slip yoke set

  • Fits 3.5 inch steel tube OD with 0.083 wall thickness
  • Fits 1310 series universal joint (see choices at bottom of page)
    • 3.219 wide cap to cap
    • 1.062 cap diameter
    • outside snap rings
  • Maximum of 3 inches slip travel
  • Spicer Slip yoke 1.375 x 16 splines has press on seal with grease fitting
  • Spicer Spline is glidecoated (blue coating) 2.25 inches for wear resistance if properly lubricated
    • Spline butt diameter to press fit into tube - 3.345 inches
Spicer
350083-51 Spline and Slip yoke set 1310 series fits 3.5 inch 0.083 wall steel tube allows maximum 3 inches of slip travel
350083-51 Spline and Slip yoke set 1310 series fits 3.5 inch 0.083 wall steel tube allows maximum 3 inches of slip travel
FOR FASTER SERVICE, PLEASE ORDER ALL PARTS ONLINE
STATUS:  IN STOCK - FREE SHIPPING
YOUR COST:  $198.95

350083-51

Spicer Spline and Slip yoke set

  • Fits 3.5 inch steel tube OD with 0.083 wall thickness
  • Fits 1310 series universal joint (see choices at bottom of page)
    • 3.219 wide cap to cap
    • 1.062 cap diameter
    • outside snap rings
  • Maximum of 3 inches slip travel
  • Spicer Slip yoke 1.375 x 16 splines has press on seal with grease fitting
  • Spicer Spline is glidecoated (blue coating) 2.25 inches for wear resistance if properly lubricated
    • Spline butt diameter to press fit into tube - 3.345 inches

The following dimensions are taken with the supplied seal installed.

  • **CL to weld Collapsed Dimension - 9.125 inches
  • **CL to weld Dimension at MID travel - 10.625 inches
  • CL to weld Fully Extended Dimension - 12.125 inches

**Caution --- Using a rubber boot in place of the seal will lengthen the collapsed and mid point dimensions. You must factor this into your build dimensions before cutting, welding and building the driveshaft

Copywrite Denny's Driveshafts

350083-51 Spline and Slip yoke set 1310 series fits 3.5 inch 0.083 wall steel tube allows maximum 3 inches of slip travel

350083-51 Spline and Slip yoke set 1310 series fits 3.5 inch 0.083 wall steel tube allows maximum 3 inches of slip travel

You May Also Need These Parts to Complete the Job

Enter your email address and we'll send you a message when this item is available

Please enter your email address in order to be notified when this item is available.
DennysDriveshaft.com - © Copyright 2024-Present

Website and Web Hosting by Online Media
Online Media - Buffalo's Web Hosting Company