Mustang 3.5 inch ALUMINUM Driveshaft 1330 Series to fit all with 3 5/8 rear u-joint width

Mustang Driveshaft 3.5 inch ALUMINUM Tubing

COMPLETE Fully Assembled High Speed High RPM Balanced Driveshaft including 28 spline transmission slip yoke and Spicer u-joints custom built to fit your Mustang

• 3.5 Inch ALUMINUM Tubing
• High Speed High RPM Balanced and Tested to be sure it will perform smoothly at all road speeds
• Maintenance Free Spicer U-joints...High Mileage and No Messy Grease Splatter
• For use in Mustangs with less than 500 horsepower.
• Maximum center to center is 57 inches  
• Your pinion yoke must be 1330 series.....3 5/8 inches between the locating tabs. 

DENNY'S 3.5 inch Ford Mustang Aluminum DRIVESHAFTS can be built to connect the transmissions listed below to any 1330 series Ford 8 inch or Ford 9 inch rear end. 

• All FORD 28 spline Manual or Automatic transmissions
• All FORD 31 spline Manual or Automatic transmissions
   

PLEASE SPECIFY: Model name or number of your transmission and also the spline count of the output shaft when ordering.

MEASUREMENTS REQUIRED TO ORDER THIS SHAFT

• CLICK HERE to View and Print DIAGRAM "B" 
  • On Diagram "B" your overall length dimension "Number B6" should be approximately 55 inches or less 

OVERSIZE PACKAGE: Sorry ... this item DOES NOT qualify for Free Shipping!