X-1378 Center Support with 1.378 bearing ID Aluminum Urethane Mount for 1958 to 1964 Chevy Car and 1960 to 1972 C-10 Truck for use with custom aftermarket driveshaft

Denny's part number X-1378

Aluminum Urethane mounted center support bearing

WILL NOT FIT STOCK DRIVESHAFT

Can be used on 2.5 inch or 3 inch diameter custom built 2 piece driveshafts that require a 1.378 ID bearing

• Ideal for building larger and stronger two piece driveshaft in 1310 or 1350 series
• Bearing ID is 1.378 for use with custom built aftermarket driveshaft
• Must be used with spline and slip style rear driveshaft section
• Aluminum Mounting fits Chevrolet Car frame
  • 1958, 1959, 1960, 1961, 1962, 1963, 1964
• Aluminum Mounting fits Chevy C-10 1/2 Ton Truck frame
  • 1960, 1961, 1962, 1963, 1964, 1965, 1966, 1967, 1968, 1969, 1970, 1971, 1972

Super Strong aircraft aluminum housing will not bend or twist.

• Bearing is suspended in Urethane and will not pull out under load like the original rubber mount did when it distorted under load.
• This could be the cure that you have been looking for to end all your problems with center hanger bearing failure
• Great for cars and trucks with hydraulic suspensions
• Comes with Mounting Bolts and washers