Click on image to zoom

UPGRADE to MW 39035 Hardened Slip Yoke necessary for Powerglide with ROLLER Bearing output when you purchase a Denny's 3.5 or 4 inch Aluminum Driveshafts

SKU: UPGRD-39035

UPGRD-39035

UPGRADE to MW 39035 Slip Yoke

Upgrade to the MW 39035 Mark Williams Enterprises Cromoly Slip yoke necessary for Powerglide with Roller Bearing output on the following Denny's Driveshafts ONLY:
- For Denny's 3.5 and 4 inch Aluminum Driveshafts

NOTE: This is an UPGRADE. This is not a part to be ordered separately.

This UPGRADE MUST be ordered along with one of the driveshafts listed.

Not Available

Pricing: $50.00

Description

UPGRD-39035

UPGRADE to MW 39035 Slip Yoke

Upgrade to the MW 39035 Mark Williams Enterprises Cromoly Slip yoke necessary for Powerglide with Roller Bearing output on the following Denny's Driveshafts ONLY:
- For Denny's 3.5 and 4 inch Aluminum Driveshafts

NOTE: This is an UPGRADE. This is not a part to be ordered separately.

This UPGRADE MUST be ordered along with one of the driveshafts listed.

1350 Series Forged 4340 Chromoly Transmission Slip Yoke

Hardened surface for use in Powerglide with Roller Bearing in tailshaft housing
Length to center of u-joint... Dimension #1 = 5 13/16 inches
Barrel Diameter... Dimension #2 = 1 1/2 inches
Barrel Length... Dimension #3 = 3 1/2 inches
U-joint cap diameter... Dimension #4 = 1 3/16 inches
U-joint width... Dimension #5 = 3 5/8 inches
Series... 1350
Spline count... 27

For Powerglide Transmission with Roller Bearing in tailshaft housing and 27 spline output .