UPGRADE MW 39057 Chromoly Slip Yoke necessary for JERICO and G-FORCE Transmissions with 32 spline ROLLER BEARING output and 1.888 barrel diameter use on Denny's NR-3CM and NR-3.5CM Driveshafts

UPGRD-39057

UPGRADE to MW 39057 Slip Yoke

• Upgrade to the Mark Williams Enterprises 39057 Chromoly Slip Yoke 1350 Series necessary for JERICO and G-FORCE Transmissions with 32 spline ROLLER BEARING output and 1.888 barrel diameter for use on the following Nitrous Ready Driveshafts ONLY:
  • For Denny's NR-3CM Nitrous Ready Driveshaft
  • For Denny's NR-3.5CM Nitrous Ready Driveshaft

NOTE: This is an UPGRADE.  This is not a part to be ordered separately. 

This UPGRADE MUST be ordered along with one of the driveshafts listed.

Hardened for use on JERICO and G-FORCE transmissions with ROLLER BEARING in tailshaft housing

• Length to center of u-joint... Dimension #1 = 6 1/8 inches
• Barrel Diameter... Dimension #2 = 1.888 inches
• Barrel Length... Dimension #3 = 4 3/16 inches
• U-joint cap diameter... Dimension #4 = 1 3/16 inches
• U-joint width... Dimension #5 =  3 5/8 inches
• Series... 1350
• Outside Snap Ring style
• Spline count... 32

For Powerglide Transmission with Roller Bearing in tailshaft housing and 27 spline output .