Dodge 3R Series Double Cardan CV Flange Yoke

Double Cardan 3R Series CV Flange Yoke to replace original equipment Dodge 4x4 CV Flange yoke. This yoke is used to replace the 4x4 double cardan CV Flange yoke located on the Front Driveshaft of a 4x4 Dodge original equiment driveshaft. CV Flange yoke comes complete with ball socket centering parts already loaded. Bolt pattern for mounting to rear differential flange is 4 1/4 inches (4.250 inches) measured diagonally and the pilot hole in the center of the flat flange is 3 1/8 inches (3.125 inches). It has 4 equally spaced holes that measure 3 inches from center of hole to center of hole.

• Dodge 3R Series Double Cardan CV Flange Yoke
• Bolt Pattern.... 4.25 inches (4 1/4 inches) measured diagonally
• Pilot Diameter... 3.125 inches (3 1/8 inches)
• Typically found on Dodge 4x4 Front Driveshafts 1973 and newer with inside "C" Clip style u-joints.
• Requires Inside "C" Clip style 3R Series u-joints listed below
• Centering ball socket comes fully assembled and ready to install