Slip Yoke 1330 series 16 spline N2-3-8041KX NEAPCO 7.5 inches

NEAPCO 1330 series Slip Yoke N2-3-8041KX

Fits Jeep Front or Rear Spline and Slip Style Driveshaft

Use this slip yoke to upgrade to 1330 series and retain your existing driveshaft.  It will fit in place of the original slip yoke on any 16 spline driveshaft with a spline diameter of 1.375 inches

Designed for 1330 series u-joint.  See bottom of this page for 1330 series u-joints

• 3 5/8 inches between snap rings
• 1 1/16 diameter bearing caps

16 splines and 1.375 inch Spline Diameter

• Fits 16 spline driveshaft with 1.375 spline Diameter
  • For proper fit be sure to Measure OUTSIDE DIAMETER of SPLINED SHAFT
  • 
• Includes press on seal
• 7.5 inches from center of u-joint bearing cap to end of yoke with seal removed. 
  • Measure from CENTER of Bearing Cap Hole to END of Yoke with seal removed
  •