Dana Spicer 3-3-2591KX Slip Yoke 1350 series 16 spline 6.625 inches

Dana Spicer 3-3-2591KX

1350 series Slip Yoke

Fits Front or Rear Spline and Slip Style Driveshaft

Use this slip yoke to upgrade to 1350 series and retain your existing driveshaft.  It will fit in place of the original slip yoke on any 16 spline driveshaft with a spline diameter of 1.375 inches

Designed for 1350 series u-joint.  See bottom of this page for 1350 series u-joints

• 3 5/8 inches between snap rings
• 1 3/16 diameter bearing caps
• Includes screw on Splined Seal Part Number D3G for use on full length splines
  
• OPTIONAL - Rubber Seal insert to replace splined seal for use on smooth neck spline. See bottom of page.

16 splines and 1.375 inch Spline Diameter

• Fits 16 spline driveshaft with 1.375 spline Diameter
  • For proper fit be sure to Measure OUTSIDE DIAMETER of SPLINED SHAFT
  • 

• 6.625 inches from center of u-joint bearing cap to end of yoke with seal removed. 
  • Measure from CENTER of Bearing Cap Hole to END of Yoke with seal removed
  •