Denny's AL3.5-1330 Aluminum Driveshaft 1330 series 3.5 inch OD tube for stock 1987 Buick Grand National

AL3.5-1330

1987 BUICK Grand National 1330 Aluminum Driveshaft 

• Aluminum Driveshaft custom built to fit your 1987 Buick Grand National
  • 1330 series
  •  3.5 inch OD x .125 wall 6061-T6 aluminum tubing
  • Comes with 1330 series Dana Spicer Transmission Slip Yoke for 27 spline 200R transmission
    
    • Chromoly slip yoke is available as an option
  • Comes with 1330 series Dana Spicer u-joints - NON Greaseable
    • Rear universal joint fits stock 3R Series rear end pinion yoke
  • High Speed - High RPM Balanced
• Complete driveshaft fully assembled and ready to install

• STOCK....Dimensions are not necessary if 1987 Buick Grand National is stock using stock 200R transmission and stock pinion yoke on 8.5 inch 10 bolt rear end.
• ALL OTHERS....Diagram "B" dimensions are required for purchase if using different model transmission or rear end or if any suspension modifications have been made. 
  • CLICK HERE to print Diagram "B"

PLEASE NOTE:  This driveshaft is sold based on stock vehicle requirements.  If your Buick Grand National has more horsepower than stock we suggest that you contact us before selecting to purchase.  Please be sure we know your engine horsepower, your engine rpm and your complete vehicle weight.  Also... if your automatic has a trans brake.  These factors will enable us to determine if this is the right shaft for you. 

OVERSIZE PACKAGE: Sorry ... this item DOES NOT qualify for Free Shipping!