I received my drive shaft the other day. It fit perfectly of course and looked so nice I hung it over the fireplace for a few days to admire it before putting it in the car.
Denny helped me with drive line angles and now the car is... ...read more
Denny's Driveshafts offer a variety of Pontiac Universal Joints. Keep in mind that your Pontiac may have any combination of u-joint sizes so please don't assume anything. Please measure your u-joint width before ordering. The 1310 u-joint will measure 3.219 wide and the 1330 will measure 3.625 wide. Both will have a 1.062 bearing cap diameter and both use outside snap rings to hold the u-joint in place. The GM 3R series is always 3.625 wide and 1.125 bearing cap diameter and uses inside "C" clips to lock the caps into place. Greaseable and non greaseable maintenance free versions are available. Our high mileage maintenance free Spicer universal joints are the best choice for long life and absolutely no greasy mess under that beautifully restored Pontiac. Denny's also carries the various Combination U-joints that allow you to connect mismatched driveline components.
Fits 3R series pinion yoke in late 60's early 70's Pontiac (BOP rear end) that require a u-bolt set
Fits 3R series universal joint with 1.125 inch caps and INSIDE "C" Clips
See 5-3147X or 5-795X universal joints at bottom of this page
Set includes (2) U-bolts and (4) cone lock nuts.
DOES NOT FIT tab style pinion yokes for 1.062 inch u-joint caps
DOES NOT FIT GM 3R series pinion yokes (no tabs) designed for straps and bolts
Some General Motors Buick Olds Pontiac and Chevy 3R series pinion yokes were designed for u-bolts in the late 60's and early 70's. These have been discontinued and became obsolete many years ago and very hard to find.
We now have them brand new and a perfect fit to replace your old set.