Denny's Driveshafts offer a variety of Chevrolet Corvette attaching hardware for the C1, C2, C3 and C4. The typical Corvette rear end pinion yoke utilizes a strap and bolt design to hold the rear universal joint into the yoke. Disconnecting the 4 bolts and 2 straps is necessary to remove the driveshaft to from the car. Denny's offers both the original equipment strap and bolt set and also the u-bolt set as replacements to match your existing pinion yoke hardware. Please measure your u-joint width before ordering. The 1310 u-joint will measure 3.219 wide and the 1330 will measure 3.625 wide. Both will have a 1.062 bearing cap diameter.
1310-1330 Series U-Bolt Set for 1953-1979 Corvette 27 spline Transmission Slip Yoke and 1953-1962 rear end pinion yoke. Use on any 1310 or 1330 series pinion yoke designed for a 1.062 ( 1 1/16th ) bearing cap diameter. U-bolt set comes with (2) U-bolts (4) lock washers and (4)nuts. Replace that old stretched out original set with a new one.
Status: IN STOCK *** This item is Online Order Only
1310-1330 Series Strap & Bolt Set for 1963-1979 C2 C3 Corvette rear end differential pinion yoke. Fits both 1310 and 1330 pinion yokes. Also fits 1330 series T-400 transmission slip yoke. Strap and bolt set comes with (2) Straps (4) Bolts. Replace that old stretched out original set with a new one.
Status: IN STOCK *** This item is Online Order Only
1310-1330 Series Strap & Bolt Set for 1980-1996 C3 C4 Corvette to connect main driveshaft to Dana 36 or Dana 44 rear end. Strap and bolt set comes with (2) Straps (4) Bolts. Replace that old stretched out original set with a new one.
Status: IN STOCK *** This item is Online Order Only
1350 Series U-Bolt Set for 1963-1979 Corvette axle half shafts. Super strong u-bolt set comes with (2) U-bolts (4) lock washers and (4) nuts. Replace that old stretched out original set with a new one.
Status: IN STOCK *** This item is Online Order Only
