One Piece 4 inch ALUMINUM DRIVESHAFT 1350 series fits 2005 to 2010 FORD MUSTANG GT with V8 DANA SPICER 10001767 FREE SHIPPING

Part Number:
10001767

UPC:

023913445409

Your Cost $779.99

Sorry, sold out

STATUS: DISCONTINUED ITEM

DANA SPICER 10001767

ONE PIECE 1350 Series 4 INCH ALUMINUM DRIVESHAFT

Fits FORD MUSTANG GT with V8 engine 2005, 2006, 2007, 2008, 2009 and 2010
4 inch Diameter .125 inch wall thickness 6061-T6 aluminum tubing
1336 mm (52.598 inches) Overall Length....face of transmission flange to face of rear end flange dimension

One Piece 4 inch ALUMINUM DRIVESHAFT 1350 series fits 2005 to 2010 FORD MUSTANG GT with V8 DANA SPICER 10001767

FREE GROUND Shipping**

**Free Ground Shipping to lower 48 States ONLY...Alaska and Hawaii at reduced rates.

One Piece 4 inch ALUMINUM DRIVESHAFT 1350 series fits 2005 to 2010 FORD MUSTANG GT with V8 DANA SPICER 10001767

FOR FASTER SERVICE, PLEASE ORDER ALL PARTS ONLINE

STATUS: DISCONTINUED ITEM

YOUR COST: $779.99

This item qualifies for FREE GROUND SHIPPING to the lower 48 states

DANA SPICER 10001767

ONE PIECE 1350 Series 4 INCH ALUMINUM DRIVESHAFT

Fits FORD MUSTANG GT with V8 engine 2005, 2006, 2007, 2008, 2009 and 2010

1336 mm (52.598 inches) Overall Length....face of transmission flange to face of rear end flange dimension
Direct BOLT IN right out of the box
Designed for Increased Horsepower applications to deliver peak endurance and optimum strength
- 4 inch Diameter .125 inch wall thickness 6061-T6 aluminum tubing
- 1350 SERIES Dana Spicer 5-1350X Universal Joints...much stronger than the 1330 series versions available for Mustangs
- Comes with 1350 series flange yoke to bolt to transmission
- Comes with 1350 series flange yoke to bolt to OE Mustang rear end flange...NO adaptor required
- Fully Assembled and Balanced
Spline and Slip design to allow for installation and suspension movement
Hard Plastic boot to keep grease in and water out to protect spline and slip from contaminants
Reduces noise, vibration and harshness in your Mustang driveline
Eliminates the need for a center support bearing
Lighter Weight than OE Driveshaft - Reduces overall weight and rotating mass
Delivers improved driving performance
Provides quicker accelleration and faster ET at the track
Built, assembled and balanced by Dana Spicer

One Piece 4 inch ALUMINUM DRIVESHAFT 1350 series fits 2005 to 2010 FORD MUSTANG GT with V8 DANA SPICER 10001767

Please enter your email address in order to be notified when this item is available.

CLOSEOUTS & CLEARANCE