DennysDriveshaft.com
Free Shipping on Orders Over $99.00

Product Search
Denny's Driveshaft builds custom steel and aluminum driveshafts for your high performance car, street rod, race car, van, pick up or 4x4 truck
 
Denny's 1963-1979 Corvette C2 and C3 Rear Axle Half Shaft 3 inch tube
Part #:
NR-3HS
Your Cost $290.95

1963-1979 Corvette C2 & C3

3 inch 1350 series Nitrous Ready Half Shaft

For Stock and High Horsepower Corvettes

PRICE SHOWN is for (1) Half Shaft

Dennys
Denny's 1963-1979 Corvette C2 and C3 Rear Axle Half Shaft 3 inch tube
Denny's 3 inch Corvette Half Shafts
STATUS:  Custom Built...Please allow at least 4 weeks at this time
YOUR COST:  $290.95

This Driveshaft comes with (1) FREE T-SHIRT

Select your size here:

 

1963-1979 Corvette C2 & C3 Rear Axle Half Shaft

3 inch 1350 series Nitrous Ready Half Shaft complete with Spicer 1350 series maintenance free u-joints and flange yoke.

 All Denny’s Corvette Axle Half Shafts are high speed balanced and come fully assembled for easy installation.

No greasy mess splattered all over that nice Corvette from these super strong and reliable u-joints and you can expect very high mileage with no maintenance.

Don’t get these confused with those inexpensive unbalanced no name shafts that seem to be all over the internet for a whole lot less.

Buy with confidence knowing that they are built with our Nitrous Ready tubing for the ultimate in strength and reliability.

  • 1350 Series
  • 3 inch Nitrous Ready Tubing
  • Spicer solid body maintenenace free 1350 series u-joints
  • Dana Spicer Flange yoke
  • High Speed Balanced and Tested
  • Painted Black
  • Fully assembled and ready to install...Direct BOLT-IN installation
  • Dimensions not necessary unless custom length is required

PRICE SHOWN is for (1) Half Shaft

     

Measure from CENTER of pressed in cap to CENTER of pressed in cap

Please measure from the exact center of the u-joint cap diameters at each end of the shaft for an accurate center to center overall length dimension to order any half shaft. Please measure the universal joint cap diameter carefully. The 1330 series (usually found on early eighty’s aluminum half shafts) will have a 1 1/16th inch (1.062) u-joint cap diameter and the 1350 series (usually found on all years steel or aluminum) will have a 1 3/16th inch (1.187) u-joint cap diameter.
Denny's 1963-1979 Corvette C2 and C3 Rear Axle Half Shaft 3 inch tube

Denny's 3 inch Corvette Half Shafts

You May Also Need These Parts to Complete the Job

Dana Spicer 3-94-18X 1350 Series U-Bolt Set for 1963-1979 Corvette axle half shafts.
$4.25

DennysDriveshaft.com - © Copyright 2017-Present

Website and Web Hosting by Online Media
Online Media - Buffalo's Web Hosting Company