One Piece 4 inch ALUMINUM DRIVESHAFT 1350 series fits 2011 to 2014 FORD MUSTANG GT with V8 DANA SPICER 10001797 FREE SHIPPING
|
|
Your Cost
$995.95
Sorry, sold out
STATUS:
DISCONTINUED ITEM
|
|
DANA SPICER 10001797
ONE PIECE 1350 Series 4 INCH ALUMINUM DRIVESHAFT
- Fits FORD MUSTANG GT with V8 engine 2011, 2012, 2013 and 2014
- 4 inch Diameter .125 inch wall thickness 6061-T6 aluminum tubing
- 1430 mm (56.299 inches) Overall Length....face of transmission flange to face of rear end flange dimension
FREE GROUND Shipping**
**Free Ground Shipping to lower 48 States ONLY...Alaska and Hawaii at reduced rates.
UPC: 023913445423
Part Number: 10001797
|
One Piece 4 inch ALUMINUM DRIVESHAFT 1350 series fits 2011 to 2014 FORD MUSTANG GT with V8 DANA SPICER 10001797
|
FOR FASTER SERVICE, PLEASE ORDER ALL PARTS ONLINE
STATUS: DISCONTINUED ITEM
YOUR COST:
$995.95
This item qualifies for FREE GROUND SHIPPING to the lower 48 states
>>>>> SPECIAL ORDER PART: This part number is special ordered from the factory and shipped direct to you. It is NOT Cancellable and NOT Returnable. Please make your selection carefully! <<<<<
|
DANA SPICER 10001797
ONE PIECE 1350 Series 4 INCH ALUMINUM DRIVESHAFT
Fits FORD MUSTANG GT with V8 engine 2011, 2012, 2013 and 2014
- 1430 mm (56.299 inches) Overall Length....face of transmission flange to face of rear end flange dimension
- Direct BOLT IN right out of the box
- Designed for Increased Horsepower applications to deliver peak endurance and optimum strength
- 4 inch Diameter .125 inch wall thickness 6061-T6 aluminum tubing
- 1350 SERIES Dana Spicer 5-1350X Universal Joints...much stronger than the 1330 series versions available for Mustangs
- Comes with 1350 series flange yoke to bolt to transmission
- Comes with 1350 series flange yoke to bolt to OE Mustang rear end flange...NO adaptor required
- Fully Assembled and Balanced
- Spline and Slip design to allow for installation and suspension movement
- Hard Plastic boot to keep grease in and water out to protect spline and slip from contaminants
- Reduces noise, vibration and harshness in your Mustang driveline
- Eliminates the need for a center support bearing
- Lighter Weight than OE Driveshaft - Reduces overall weight and rotating mass
- Delivers improved driving performance
- Provides quicker accelleration and faster ET at the track
- Built, assembled and balanced by Dana Spicer
|
One Piece 4 inch ALUMINUM DRIVESHAFT 1350 series fits 2011 to 2014 FORD MUSTANG GT with V8 DANA SPICER 10001797
|
|