| 1963-1979 Corvette C2 & C3 Rear Axle 3 inch Half Shaft | ||||
|
||||
|
1963-1979 Corvette C2 & C3 3 inch 1350 series Nitrous Ready Half Shaft For Stock and High Horsepower Corvettes |
||||
Denny's 3 inch Corvette Half Shafts
|
$235.95 each
STATUS: Custom Built...Please allow at least 2 weeks at this time
|
|||
|
1963-1979 Corvette C2 & C3 Rear Axle 3 inch 1350 series Nitrous Ready Half Shaft complete with Spicer 1350 series maintenance free u-joints and flange yoke. All Denny’s Corvette Axle Half Shafts are high speed balanced and come fully assembled for easy installation. No greasy mess splattered all over that nice Corvette from these super strong and reliable u-joints and you can expect very high mileage with no maintenance. Don’t get these confused with those inexpensive unbalanced no name shafts that seem to be all over the internet for a whole lot less. Buy with confidence knowing that they are built with our Nitrous Ready tubing for the ultimate in strength and reliability.
|
||||
 Measure from CENTER of pressed in cap to CENTER of pressed in cap Please measure from the exact center of the u-joint cap diameters at each end of the shaft for an accurate center to center overall length dimension to order any half shaft. Please measure the universal joint cap diameter carefully. The 1330 series (usually found on early eighty’s aluminum half shafts) will have a 1 1/16th inch (1.062) u-joint cap diameter and the 1350 series (usually found on all years steel or aluminum) will have a 1 3/16th inch (1.187) u-joint cap diameter. |
||||
|
||||
Additional Items to Complete the Job
|
||||
|
||
