How To Measure n Nitrous Ready Driveshafts n Heavy Duty Driveshafts n 6061-T6 Aluminum Driveshafts n HD Aluminum Driveshafts

Economy Driveshafts n 2 Piece Driveshafts n 4X4 Driveshafts n Cobra Kit Car Driveshafts n Corvette Half Shafts n Free Lifetime Labor

Weekly Specials n Pinion Yokes & Transfer Case Yokes n Transmission Slip Yokes & Transfer Case Slip Yokes n Repair Service

Denny's Driveshaft builds custom Steel and Aluminum driveshafts for your high performance car, street rod, race car, van, pick up or 4x4 truck.

Measuring Questions & Pricing 716-875-6640         Orders Only 1-800-955-1872

How To Measure Correctly

We have designed the best measuring sheets in the industry. These drawings will guide you to measure your application correctly to ensure proper fit and performance each and every time.
 
IT'S EASY TO GET IT RIGHT THE FIRST TIME...
To measure cars and trucks properly...Place two safety stands under the differential housing tubes to support vehicle.
Step #1. Pick the Diagram that looks like your application...PRINT it OUT and fill in the answers...be sure to MEASURE EXACTLY as it shows.  Diagrams "B" & "C" are USED MOST OFTEN for street rods and race cars.

Step #2. You will need a tape measure and a good 6" ruler. Remember to always measure your application with the rear tires on the ground or the rear end on 2 safety stands. If measuring 4X4 trucks you must have both the front and rear tires on the ground or the axles supported on safety stands. 

Step #3. Each DIAGRAM will give you spaces to fill in and choices for the different possibilities...Please remember we will need ALL the questions answered for the DIAGRAM you are using to quote a price or build a shaft.

Step #4. CALL 716-875-6640 for measuring questions. CALL 800-955-1872 to place your order.
  ***************************************************************************************************************************************
 
Most of you with CAR or 2 Wheel Drive truck applications will use Diagram “ B or C ". Please see Diagram " D & E " for measuring the rear u-joint. Some FORD applications may use Diagrams " J & K "

For 4X4 applications see DIAGRAMS " A, B, C, D, E, F, G, H, J & K " Use " F & G " for most 4X4 Front shafts and " B & G " for most Rear shafts Some FORD Rear shafts use Diagram " B, H, K & L "

For Bronco ll applications we have a much stronger upgrade so please see Diagram " H "
  ***************************************************************************************************************************************
If you have an application that does not match one of the drawings please call for instructions.

For VAN & PICK-UP  2 piece shafts with a center support bearing see Diagrams " M, N and O "

Diagram " O " is used for early GM CARS and TRUCKS with the "X" FRAME construction.

If you have an application that does not match one of the drawings please call for instructions.  

If you cannot VIEW or PRINT the MEASURING SHEET.
  
Please send us an E-MAIL requesting the measuring sheet and give us your complete name and address and we will be happy to send it out by US. mail.
 
If you need immediate assistance Please call (716) 875-6640 and one of our tech advisors will instruct you on how to measure. For business hours see our Contact Us page
 

Designed and hosted by:
Online Media, Inc.